User Tools

Site Tools


heater_fabrication

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
heater_fabrication [2020/02/25 12:54] gerryheater_fabrication [2020/02/25 12:58] gerry
Line 8: Line 8:
 {{ :heater:heater_parts_before_assembly.jpg |}} {{ :heater:heater_parts_before_assembly.jpg |}}
  
-==== Resistor Location ====+===== Resistor Location =====
  
 The leads of the heater resistor should not protrude far beyond the edge The leads of the heater resistor should not protrude far beyond the edge
Line 45: Line 45:
 Change the position of the spreader in the vise, and use a file to remove the burr. Change the position of the spreader in the vise, and use a file to remove the burr.
  
-Make sure the surface of the spreader is above the vise.  You don't want to dull the file or scratch the vise by filing the vise instead of the burr.+Make sure the surface of the spreader protrudes above the vise jaws.  You don't want to dull the file or scratch the vise by filing the vise instead of the burr.
  
 {{ :heater:heater_drill_burr_file.jpg |}} {{ :heater:heater_drill_burr_file.jpg |}}
heater_fabrication.txt · Last modified: 2020/02/25 12:58 by gerry