Differences

This shows you the differences between two versions of the page.

--- heater_fabrication [2020/02/25 12:54] – gerry
+++ heater_fabrication [2020/02/25 12:58] (current) – gerry
@@ Line 8: / Line 8: @@
 {{ :heater:heater_parts_before_assembly.jpg |}}
-==== Resistor Location ====
+===== Resistor Location =====
 The leads of the heater resistor should not protrude far beyond the edge
@@ Line 45: / Line 45: @@
 Change the position of the spreader in the vise, and use a file to remove the burr.
-Make sure the surface of the spreader is above the vise.  You don't want to dull the file or scratch the vise by filing the vise instead of the burr.
+Make sure the surface of the spreader protrudes above the vise jaws.  You don't want to dull the file or scratch the vise by filing the vise instead of the burr.
 {{ :heater:heater_drill_burr_file.jpg |}}
@@ Line 54: / Line 54: @@
-==== Attach the resistor to the heat spreader ====
+===== Attach the resistor to the heat spreader =====
 Secure the resistor to the heat spreader with the small screw.  The screw should be snug.  Be careful not to over-tighten the screw as you may strip the soft Aluminum.