ME 121

User Tools

Site Tools

Trace:
heater_fabrication

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
heater_fabrication [2020/02/25 12:58] – gerryheater_fabrication [2020/02/25 12:58] (current) – gerry
Line 54: Line 54:
  
  
-==== Attach the resistor to the heat spreader ====+===== Attach the resistor to the heat spreader =====
  
 Secure the resistor to the heat spreader with the small screw.  The screw should be snug.  Be careful not to over-tighten the screw as you may strip the soft Aluminum.  Secure the resistor to the heat spreader with the small screw.  The screw should be snug.  Be careful not to over-tighten the screw as you may strip the soft Aluminum. 
heater_fabrication.txt · Last modified: 2020/02/25 12:58 by gerry